Sub-Membrane Depressurization for Exposed Soil

Crawl Space Radon Mitigation in Draper & South Valley

Exposed dirt under your home or basement addition? Request a free sub-membrane radon mitigation quote from an independent certified Utah contractor.

Why Do Vented Crawl Spaces Still Pull Radon Into Utah Homes?

Many homeowners in older South Salt Lake Valley neighborhoods — including mid-century ramblers and tri-levels in Murray, Midvale, Holladay, White City, Cottonwood Heights, and historic Draper or Bluffdale — assume open foundation vents keep crawl space radon from entering living areas. Utah DEQ's Radon Techniques for New Home Construction explains why that assumption fails: even with crawl space vents, the slight indoor vacuum created by a heated home still exerts downward suction on the crawl space, pulling radon gas directly out of exposed earth and upward through subfloor framing, plumbing cutouts, and HVAC ductwork.

Crawl spaces also show up in newer hillside builds along Corner Canyon, SunCrest, and East Sandy whenever a garage, porch, or stepped upper wing transitions to an earthen storage void beside a concrete basement.

How Does Sub-Membrane Depressurization Stop Crawl Space Radon?

The U.S. EPA's Consumer's Guide to Radon Reduction identifies sub-membrane suction (sub-membrane depressurization) as the most effective radon reduction method for crawl space homes when properly applied, delivering typical reductions of 50 to 99 percent. By contrast, the EPA warns that active crawl space depressurization (simply blowing air out of the open crawl space without a membrane) generally does not work as well, can draw conditioned indoor air downward, and may raise heating and cooling costs — or risk backdrafting combustion appliances.

Utah DEQ & EPA Technical Specifications for Crawl Space Liners

Utah DEQ details the key elements of a durable sub-membrane installation:

  • Membrane thickness and durability: Utah DEQ specifies 6-mil polyethylene as the minimum liner thickness, while noting that a more durable cross-linked polyethylene sheet (often white for brighter visibility) is typically preferred if homeowners enter the crawl space for storage or mechanical maintenance.
  • Generous overlaps and slack: Seams must overlap by at least 12 inches, and perimeter edges must extend roughly 12 inches up the foundation walls for reliable adhesion. Installers leave enough slack so vacuum pressure draws the membrane snugly against soil contours instead of stretching it tight over depressions.
  • Sealed penetrations and walls: Every perimeter edge, support pier, footing column, and plumbing pipe is mechanically fastened and sealed airtight to prevent indoor air from leaking underneath.
  • Sub-membrane collection piping: Utah DEQ calls for a minimum of 10 feet of 3-inch corrugated perforated ADS pipe laid beneath the plastic sheeting and tied into a rigid vent riser powered by a continuously running radon exhaust fan.
  • Combined slab + crawl space systems: If your home has both a concrete basement and an adjacent dirt crawl space, Utah DEQ notes a contractor can tie both zones into a single vent riser and exhaust fan.

Utah DEQ also notes a helpful side benefit: sub-membrane systems significantly reduce soil moisture moving upward into floor joists, helping curb musty odors and dampness. Because crawl space dimensions, access hatches, and pier counts vary dramatically from house to house, public agencies do not publish a single flat crawl space price table; an on-site measurement from a certified contractor is the only reliable way to price the job.

Get a Free Estimate

Areas We Cover in South Salt Lake Valley

Key Parts of a Proper Crawl Space Radon System

Effective crawl space mitigation combines airtight containment with continuous negative pressure beneath the liner, following EPA and Utah DEQ guidance.

High-Durability Vapor Barrier Membrane

Minimum 6-mil polyethylene — or reinforced cross-linked liner when the space is used for storage or furnace access — cut with 12-inch overlaps and sealed 12 inches up perimeter foundation walls.

Perforated Sub-Membrane Collection Loop

At least 10 feet of 3-inch perforated corrugated pipe (or radon mat) laid beneath the membrane so the exhaust fan pulls gas evenly across the entire dirt floor rather than collapsing plastic over a single suction spot.

Split-Foundation Basement + Crawl Tie-In

Common in tri-levels and remodeled homes across Holladay, Cottonwood Heights, Murray, and Sandy: one riser connects both the basement slab suction pit and the sealed crawl space membrane to one fan.

Continuous Fan & Manometer Warning Device

EPA requires an active warning device (such as a U-tube manometer) on every active sub-membrane system, plus post-mitigation testing within 30 days to verify indoor levels fell below 4.0 pCi/L.

Why Use a Referral for Crawl Space Radon Mitigation?

Specialists in Split & Older Foundations

Many South Valley tri-levels and additions need combined slab-plus-crawl-space designs. We route your inquiry to independent pros equipped for both.

Honest About Custom Site Pricing

Rather than guessing square-foot liner rates, we connect you with a certified contractor who measures your actual crawl space before quoting.

EPA & Utah DEQ Best Practices

We explain why sub-membrane suction outperforms open crawl space venting so you can ask informed questions during contractor walkthroughs.

Free Homeowner Matching

Submitting our estimate form costs nothing and lets you compare independent bids before committing to any work.

Contact Us Today for a Free Estimate

Have an exposed crawl space or split-level foundation in Draper or southern Salt Lake County? Submit our form to request a free sub-membrane mitigation estimate.

Get a Free Estimate

Free — no obligations

What to Expect During a Crawl Space Radon Mitigation Quote & Install?

Describe your crawl space online

Note approximate square footage, ceiling clearance, whether you also have a basement slab, and your radon test number on our estimate form.

On-site crawl space inspection

An independent certified contractor checks soil grading, debris, piers, HVAC returns, and routing paths, then provides a free written quote.

Floor prep and perforated pipe layout

Sharp rocks or debris that could puncture the membrane are cleared, and perforated collection piping is positioned beneath the liner footprint.

Membrane sealing and riser connection

Heavy plastic sheeting is laid with slack, seams are sealed airtight, edges are bonded to foundation walls and piers, and the pipe vents outdoors.

Fan startup and follow-up test

The fan runs continuously to hold vacuum under the liner; a post-mitigation test between 24 hours and 30 days verifies safe indoor radon levels.

Radon Mitigation Services Available in Draper, UT

Get a Free Estimate