Active Soil Suction for Basements & Slabs

Sub-Slab Depressurization in Draper, UT

Have a basement or concrete slab testing above 4.0 pCi/L? Request a free quote for active sub-slab depressurization from an independent certified pro.

Why Is Sub-Slab Depressurization the Standard Fix for Draper Basements?

Active sub-slab depressurization (often called active sub-slab suction) is identified by the U.S. EPA as the most common and usually the most reliable radon reduction method for houses built on concrete slabs or full basements. Because heated homes in Draper, Sandy, South Jordan, and Herriman naturally maintain slightly lower indoor air pressure than the surrounding soil — especially during cold Wasatch Front winters when rising warm air intensifies the stack effect — radon is continuously pulled upward through hairline slab cracks, control joints, and floor-to-wall cold joints.

Utah DEQ describes the physical goal plainly: a sub-slab depressurization system creates a vacuum beneath the concrete foundation that is stronger than the vacuum applied to the soil by the house itself. Instead of seeping into your finished basement bedroom or family room, soil gas flows sideways through the gravel or native sub-slab fill toward a single suction pit (or multiple pits on larger footprints) and exits safely above your roofline.

How Does Local South Valley Soil Affect Sub-Slab Design?

The EPA notes that sub-slab suction works best when air moves freely underneath the concrete slab. Along the Wasatch east bench — including Corner Canyon, Granite, and East Sandy — Utah Geological Survey studies (PI-18 and SS-85) describe coarse, permeable alluvial and glacial bench sediments derived from Wasatch granitic rock. Those permeable sands and gravels allow both radon migration and strong vacuum communication under a slab. Conversely, valley-floor clay pockets near the Jordan River in Murray, Midvale, or parts of Bluffdale — or heavily compacted fill under hillside SunCrest walkouts — can restrict airflow and require pressure-field extension (PFE) testing, larger suction pits, a higher-suction fan, or a second suction point.

Key EPA & Utah DEQ Installation Standards to Look For

  • Foundation core and piping: Typically a five-inch hole cored through the basement slab connected to four-inch Schedule 40 PVC vent pipe, with accessible slab cracks and sump covers sealed tight.
  • Safe fan placement: Per EPA guidelines, the radon exhaust fan must never be installed inside or below a livable space — it belongs in an unconditioned attic, above an attached garage, or on the exterior wall so pressurized exhaust pipe never runs through bedrooms or basements.
  • Code-compliant exhaust discharge: The vent pipe must discharge above the roof surface, at least 10 feet above the ground, and at least 10 feet away from windows, doors, or openings where gas could re-enter.
  • System indicator: A visible vacuum warning device (typically a liquid U-tube manometer) mounted on the interior riser confirms continuous fan operation.

Submit our online form and we will forward your foundation details to an independent NRPP- or NRSB-certified Utah contractor for a free sub-slab depressurization quote.

Get a Free Estimate

Areas We Cover in South Salt Lake Valley

Sub-Slab Configurations Used Across South Salt Lake Valley Homes

No two Draper or South Valley basements share identical framing, footing walls, or sub-slab fill. Certified mitigators adapt sub-slab suction to your specific layout.

Single-Point Interior or Garage-Attic Suction

EPA notes that many homes with permeable sub-slab gravel need only one suction point. Routing the four-inch PVC pipe through a mechanical room or attached garage into the attic keeps exterior siding clean for HOA neighborhoods.

Multi-Point Suction for Large or Stepped Slabs

Deep hillside walkouts in SunCrest and Corner Canyon, or remodeled ramblers in Holladay and Cottonwood Heights with interior footing walls, may need two tied suction points to pull uniform negative pressure under every room.

Sump-Pit Depressurization Tie-In

Where perimeter drain tile drains to a basement sump crock, sealing the pit with a clear gasketed lid and pulling suction from the crock often extends vacuum reach around the entire foundation perimeter.

Block-Wall & Combined Foundation Suction

In older hollow-block foundations across Murray, Midvale, or Taylorsville, EPA notes contractors can combine sub-slab suction with hollow block-wall suction so gas cannot bypass the slab inside masonry cavities.

Published Utah Sub-Slab System & Operating Benchmarks

ComponentPublished FigurePublic Source
Active sub-slab system (existing home)Around $2,000Utah DEQ (High Radon Levels)
Active system in an existing structure$1,200 to $1,700Utah Geological Survey
Average mitigation install (real estate)Average $1,800Utah DEQ (Real Estate Guide)
Continuous fan electricity costAbout $8 to $10 / monthUtah DEQ (High Radon Levels)
Expected fan replacement intervalAfter about 15 yearsUtah DEQ (High Radon Levels)

Typical EPA-documented reductions for active sub-slab depressurization are 50 to 99 percent (versus 30 to 70 percent for passive sub-slab pipes). Final pricing comes from the independent certified contractor after inspecting your slab and routing path.

Why Use a Referral for Sub-Slab Depressurization?

Matched With Experienced Slab Mitigators

We connect your inquiry to independent pros familiar with both permeable Wasatch bench gravels and tighter valley-floor clays.

Attention to Finished Basements & HOAs

Describe your finished basement or HOA guidelines on the form so the contractor prepares discreet interior-chase or garage-attic routing options.

Utah License & Certification Transparency

Utah DEQ requires a Utah DOPL contractor license plus NRPP or NRSB certification for installations, along with required electrical permits when wiring fans.

Free Homeowner Referral

There is zero cost to request an estimate through our site, and no commitment until you choose a contractor and approve their written quote.

Contact Us Today for a Free Estimate

Need an active sub-slab depressurization quote for your Draper or South Valley home? Send your foundation details online to hear from an independent certified pro.

Get a Free Estimate

Free — no obligations

How Do Certified Pros Size and Install a Sub-Slab System?

Share your foundation and routing goals

Tell us via the estimate form whether your basement is finished, if you have a sump pit, and whether you prefer attic or exterior fan placement.

Site walk and communication assessment

The independent contractor inspects mechanical rooms, garage ceilings, sub-slab footing breaks, and roofline exhaust clearances before quoting.

Core drilling and suction pit excavation

Once hired, the mitigator cores the concrete slab, removes a bucket-sized pocket of sub-slab material to create an airflow plenum, and seals the collar.

PVC riser, attic/exterior fan & electrical

Four-inch PVC pipe is sloped for condensation drainage up to an attic or exterior inline fan, wired per required local permits, and vented above the roof.

Manometer labeling and 24h–30d retest

The contractor installs and marks the vacuum gauge, labels the pipe, and outlines post-mitigation testing to verify levels dropped below target.

Radon Mitigation Services Available in Draper, UT

Get a Free Estimate