Radon-Resistant New Construction (RRNC)

New Construction Radon Systems in Draper & South Valley

Building on the Traverse bench, west valley, or a custom Draper lot? Submit your plans online to connect with an independent certified Utah radon pro.

Why Build Radon-Resistant Features Into a New South Valley Home?

Across rapidly growing parts of southern Salt Lake County — from Herriman (which grew from 55,175 residents in 2020 to 62,352 in 2024 per U.S. Census estimates) and South Jordan (77,485 to 86,156) to Bluffdale, Riverton, and custom bench lots in Draper's SunCrest and Corner Canyon — homeowners often assume brand-new foundations keep radon out. In reality, modern energy-efficient construction reduces outdoor air leakage, while deep finished basements increase soil-to-concrete contact area.

According to the Utah Geological Survey (UGS), Utah adopted the 2015 International Residential Code (IRC) statewide while omitting Appendix F (Radon Control Methods), meaning radon-resistant features are not legally mandated statewide. However, UGS explicitly recommends following Appendix F voluntarily, noting that radon-resistant measures cost around $500 during new home construction compared with $1,200 to $1,700 (or around $2,000 per Utah DEQ) for retrofitting an active system later.

Why Can't You Just Test the Lot Soil Before Pouring Concrete?

Utah DEQ's Radon Techniques for New Home Construction answers this common builder question directly: soil testing a vacant lot cannot reliably predict indoor radon levels after construction, because excavation, compacted fill, sub-slab gravel, and the eventual indoor vacuum created by HVAC equipment all alter gas pathways. Moreover, lot soil testing is expensive compared with simply roughing in a passive system while the foundation and walls are open.

What Are the Five EPA Radon-Resistant Construction Features?

Both the U.S. EPA (Radon-Resistant Construction Basics and Techniques) and Utah DEQ outline five straightforward steps installed before drywall closes up the framing:

  • Gas-permeable sub-slab layer: A continuous 4-inch layer of clean, coarse washed gravel (1/2-inch to 3/4-inch) beneath the slab — or a perforated soil-gas loop / collector mat per Utah DEQ — so radon moves freely toward the vent riser.
  • Plastic vapor retarder: Heavy-duty 6-mil polyethylene sheeting laid over the gravel (or sealed over crawl space earth) before pouring concrete.
  • Sealed foundation openings: Caulking slab perimeter joints, control cracks, and plumbing penetrations with polyurethane caulk.
  • Interior warm-chase vent pipe: A 3-inch or 4-inch PVC vent pipe routed straight through conditioned interior framing (such as a furnace flue chase) above the roofline and clearly labeled "Radon System". Utah DEQ notes that routing the pipe through warm interior space creates a natural thermal draft that often allows passive operation without a fan.
  • Attic electrical junction box: Pre-wiring a dedicated electrical junction box in the attic so an exhaust fan can be spliced cleanly later if needed.

Passive Systems Still Require Post-Occupancy Testing

The EPA estimates passive sub-slab systems reduce indoor radon by 30 to 70 percent, and stresses that every new home with radon-resistant features must still be tested after occupancy. If levels test at 4.0 pCi/L or higher, a certified mitigator can activate the pre-wired attic pipe with a fan without cutting finished basement walls or running exterior conduits. Utah DEQ adds that well-built passive systems also reduce soil moisture migration under slabs.

Get a Free Estimate

Areas We Cover in South Salt Lake Valley

Five Core Elements of Radon-Resistant New Construction (RRNC)

Installing these five EPA and Utah DEQ components before concrete pour and drywall saves substantial retrofit expense and keeps piping hidden inside interior walls.

4-Inch Washed Aggregate or Collector Loop

Creates an unobstructed airflow layer beneath basement and walkout slabs so soil gas flows evenly to the vent pipe instead of seeping through concrete.

6-Mil Polyethylene Vapor Retarder

Separates the concrete pour from sub-slab gravel and slows both radon gas and ground moisture from migrating into basement living spaces.

Warm-Chase PVC Vent Riser (Labeled)

A 3-inch or 4-inch PVC stack run vertically through interior heated space to the roof and labeled 'Radon System' to establish passive upward draft.

Polyurethane Joint & Penetration Sealing

Sealing perimeter joints, sump crocks, and utility sleeves restricts indoor air leakage and boosts passive or future active vacuum performance.

Pre-Wired Attic Junction Box

Eliminates costly future electrical fishing by placing power right beside the attic pipe stack in case post-occupancy testing shows a fan is needed.

Published Utah New-Build vs. Retrofit Cost Comparison

ApproachPublished FigurePublic Source
Radon-resistant features during new constructionAround $500Utah Geological Survey
Active mitigation retrofit in an existing home$1,200 to $1,700Utah Geological Survey
Active mitigation retrofit (Utah DEQ guide)Around $2,000Utah DEQ (High Radon Levels)
Passive system typical radon reduction30% to 70% (test after occupancy)U.S. EPA Consumer's Guide
Active system typical radon reduction50% to 99%U.S. EPA Consumer's Guide

EPA notes builder costs for radon-resistant features vary widely by floor plan and local labor, though they are typically lower than retrofitting after move-in. Ask an independent certified radon pro to quote your blueprints.

Why Use a Referral for New Construction Radon Systems?

Avoid Cutting Fresh Finished Basements

Coordinating an interior chase before drywall avoids exterior conduit runs on custom Draper, SunCrest, Herriman, or South Jordan homes.

Clear on Utah Code vs. Best Practice

We state honestly that Utah omitted IRC Appendix F statewide, while sharing why UGS and Utah DEQ recommend passive rough-ins anyway.

Independent Pro Coordination

We forward your building timeline to an independent certified radon professional who can quote rough-in work or consult directly with your builder.

Zero Referral Cost

Homeowners and custom home builders pay nothing to request a free estimate through our referral service.

Contact Us Today for a Free Estimate

Breaking ground in Draper or southern Salt Lake County? Share your build stage online to connect with an independent certified Utah radon professional.

Get a Free Estimate

Free — no obligations

How Do Homeowners & Builders Coordinate a New-Build Radon System?

Share your floor plan stage online

Let us know your lot city, foundation type (full basement, walkout, or split), and construction schedule on the estimate form.

Pre-pour sub-slab design review

An independent certified radon pro coordinates gravel specs, T-fitting placement, crawl space liners, and wall chase alignment before concrete pour.

Rough-in vent riser and attic power

During framing and mechanical rough-in, the labeled PVC pipe runs vertically through a warm chase to the roof with an attic junction box nearby.

Sealing before basement finish

Foundation joints, utility penetrations, and sump pits are sealed with polyurethane caulk prior to flooring and drywall completion.

Post-occupancy radon verification test

Once heating and ventilation operate normally after move-in, test the lowest livable floor to verify whether passive draw suffices or a fan should be added.

Radon Mitigation Services Available in Draper, UT

Get a Free Estimate